MPP Solar PIP-MS 1-5KVA Instrukcja Użytkownika Pobierz pdf (Strona 3)

Step 7: Put communication board back to the unit.

Step 8: Put wire cover back to the unit. Now the inverter is providing parallel operation

function.

4. Mounting the Unit

When installing multiple units, please follow below chart.

500mm 500mm 500mm 500mm500mm

500mm

NOTE: For proper air circulation to dissipate heat, allow a clearance of approx. 50 cm to the

side and approx. 50 cm above and below the unit. Be sure to install each unit in the same level.

5. Battery Connection

WARNING! Be sure that all inverters will share the same sets of batteries. Otherwise, the

inverters will transfer to fault mode.

WARNING: Be sure the length of all battery cables is the same. Otherwise, there will be

voltage difference between inverter and battery to cause parallel inverters not working.

Follow below chart to connect batteries. All battery cables are connected from inverters to

batteries via the same BUS bar.

1 2 3 4 5 6 7 8 ... 11 12

Brak uwag

MPP Solar PIP-MS 1-5KVA Instrukcja Użytkownika Strona 3